Heads up: we research and compare the products we recommend, and we only link to gear we would consider buying ourselves. When you buy through links on this page we may earn a commission, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.
SCRIB3D PLA Refills, 20 Colours (1.75 mm)
Description
The refill pack from the brand behind the SCRIB3D P1: twenty colours of 1.75 mm PLA, 16 ft of each, made to run at the same 160–210 °C the P1 publishes for PLA. Each colour is vacuum packed, so it stays dry until you open it.
Key specifications
| Material | PLA, 1.75 mm |
|---|---|
| Colours | 20 |
| Length | 16 ft (about 4.9 m) per colour, about 100 m in total |
| Printing temperature | 160–210 °C |
| Packaging | Each colour vacuum packed |
| Fits | SCRIB3D, PIKA3D, MYNT3D and most pens that take 1.75 mm PLA, according to SCRIB3D |
Worth knowing before you buy
- SCRIB3D says these don’t fit the 3Doodler Create+. They don’t suit low-temperature pens such as the 3Doodler Start either.
- Keep opened colours in a sealed bag: filament that has taken on moisture can bubble in a hot pen.
Specifications as published by SCRIB3D on its official listing, checked October 2026. Where a figure isn’t published, we say so.
