Heads up: we research and compare the products we recommend, and we only link to gear we would consider buying ourselves. When you buy through links on this page we may earn a commission, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.
SCRIB3D P1 3D Pen with Display
Description
The P1 heats PLA and ABS within ranges SCRIB3D publishes, and its stepless slider lets you slow right down for detail or speed up for infill. SCRIB3D sells it for ages 14 and up, and it arrives ready to use, with starter filament and a stencil guide in the box.
Key specifications
| Age | 14+, according to SCRIB3D (its 2022 manual says adult use only) |
|---|---|
| Filaments | PLA and ABS, 1.75 mm |
| Temperature | PLA 160–210 °C · ABS 210–235 °C on the Amazon listing, 200–230 °C in the manual |
| Speed control | Stepless slider |
| Nozzle | Ceramic |
| Auto sleep | After 2 minutes without use (listing) or 5 minutes (manual) |
| Power | 5 V 2 A adapter; the manual says a power bank of at least 2 A also works |
| In the box | 3 colours of PLA (30 ft in total), power adapter, manual, stencil guide |
Worth knowing before you buy
- No built-in battery: it runs from the adapter or, according to SCRIB3D’s manual, a power bank of at least 2 A.
- The starter filament covers a few small projects; budget for a refill pack.
- ABS needs the higher temperature setting and a well-ventilated room.
Specifications as published by SCRIB3D on its official listing, checked October 2026. Where a figure isn’t published, we say so.
