Heads up: we research and compare the products we recommend, and we only link to gear we would consider buying ourselves. When you buy through links on this page we may earn a commission, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.
LIHUACHEN RPC200B 3D Pen (Button Version)
Description
The button version of the RPC200B runs everything from one control: heating, feeding, pausing and speed, according to LIHUACHEN. It holds PLA at a fixed 190–210 °C, so there is nothing to set, and it arrives ready to draw with twelve colours of filament.
Key specifications
| Filament | PLA, 1.75 mm |
|---|---|
| Temperature | 190–210 °C, set automatically |
| Controls | One button for heating, feeding, pausing and speed |
| Nozzle | Ceramic |
| Warm-up | About 60 seconds, according to LIHUACHEN |
| Power | Corded: plug in before use |
| Age | 7 and over, according to LIHUACHEN |
| In the box | Pen, 12 colours of PLA, finger guard, drawing templates |
Worth knowing before you buy
- It takes PLA only: the listing doesn’t cover ABS or low-temperature plastics.
- The ceramic nozzle gets hot. Under-tens should draw with an adult beside them.
- The listing doesn’t say how much filament comes with each colour.
Specifications as published by LIHUACHEN on its official listing, checked October 2026. Where a figure isn’t published, we say so.
