Heads up: we research and compare the products we recommend, and we only link to gear we would consider buying ourselves. When you buy through links on this page we may earn a commission, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.
Anycubic Wash & Cure 3 Station
Description
For smaller resin printers, the Wash & Cure 3 handles post-processing on a 22.5 × 23.5 cm footprint. Its basket sits at two heights, so a short build plate needs less alcohol, and a gooseneck lamp can cure a spot the main cure missed.
Key specifications
| Largest wash size | 165 × 100 × 180 mm (3 litres) |
|---|---|
| Bucket | 4 litres in total |
| Curing area | Up to 160 × 180 mm |
| Basket | Two heights: 100 and 165 mm |
| Timer | 1–30 minutes, rotary knob |
| Extra | Gooseneck light for local curing |
| Fits | Printers of 7.3 inches and below, including the Photon Mono 4 series, according to Anycubic |
| Size and weight | 22.5 × 23.5 × 36.5 cm, 3.6 kg |
Worth knowing before you buy
- Too small for 10-inch printers: for the Saturn 4 Ultra 16K, look at the Elegoo Mercury Plus V3.0.
- Used alcohol carries uncured resin: never pour it down the drain.
Specifications as published by Anycubic on its official listing, checked October 2026. Where a figure isn’t published, we say so.
