Heads up: we research and compare the products we recommend, and we only link to gear we would consider buying ourselves. When you buy through links on this page we may earn a commission, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.
Elegoo Mercury Plus V3.0 Wash & Cure Station
Description
Every resin print needs two jobs once it leaves the printer: a wash to remove liquid resin, then a UV cure to harden it. The Mercury Plus V3.0 does both in one footprint, with a stirring wash tank and a 360° turntable under 24 UV LEDs, each timed up to 30 minutes.
Key specifications
| Wash tank | 7.5 litres |
|---|---|
| Largest part, basket mode | 230 × 135 × 260 mm |
| Largest part, on the build plate | 214 × 135 × 180 mm |
| Curing | 360° turntable, 24 UV LEDs at 405 nm |
| Timer | Up to 30 minutes for washing or curing |
| Safety | Cover blocks 99.9 % of UV, according to Elegoo; curing stops when it is lifted |
| Size and weight | 30.3 × 30.3 × 41.3 cm, 6.2 kg |
Worth knowing before you buy
- Fill the tank with the cleaning liquid your resin’s maker specifies. Either way, the used liquid carries uncured resin and must not go down the drain.
- At 41 cm tall, check the shelf height before you buy.
Specifications as published by Elegoo on its website and official listing, checked October 2026. Where a figure isn’t published, we say so.
