Heads up: we research and compare the products we recommend, and we only link to gear we would consider buying ourselves. When you buy through links on this page we may earn a commission, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.
Anycubic Photon Mono 4 Resin 3D Printer
Description
The Photon Mono 4 is the smaller, simpler way into resin. Its 7-inch 10K screen resolves 17 µm pixels, enough for miniatures and jewellery, and its levelling is done once, by hand, with four screws.
Key specifications
| Type | MSLA resin |
|---|---|
| Screen | 7-inch 10K mono LCD, 9,024 × 5,120 px |
| XY resolution | 17 × 17 µm |
| Build volume | 153.4 × 87 × 165 mm |
| Light source | LighTurbo matrix |
| Platform | Laser-engraved Platform 2.0 |
| Levelling | 4-point manual, needed once, according to Anycubic |
| Other | Resume after power loss |
Worth knowing before you buy
- The platform is small: think miniatures and jewellery rather than large models.
- Resin printing needs gloves, ventilation and a wash-and-cure step in isopropyl alcohol and UV light.
Specifications as published by Anycubic on its official listing, checked October 2026. Where a figure isn’t published, we say so.
